Services

Washing machine repair, part by part.

Eight services, one specialism. A technician finds the fault at your door and you get the price before any work starts.

Close-up of a front load washing machine drum behind its glass door
01

Front load washing machine repair

Front loaders carry the most electronics and the tightest fit of any washer. We find the fault at your door, from the control board to the door lock, pump and bearings, and fix it there wherever the part allows.

  • Error code diagnosis and reset
  • Door lock and handle repair
  • Drain pump and filter clearing
  • Full body and cabinet replacement
Book this repair Price agreed before any work starts.
A white top load washing machine and dryer in a laundry room
02

Top load and semi-automatic repair

Fully automatic top loaders and semi-automatic twin tubs wear out in the same places: gearboxes, belts, lid switches and timers. Most of them are back to work after a single visit.

  • Wash and spin motor repair
  • Gearbox, clutch and belt replacement
  • Lid switch and timer repair
  • Inlet and drain hose fixes
Book this repair Price agreed before any work starts.
A technician testing a washing machine control board with a multimeter
03

PCB and motherboard repair

A failed control board does not always need a new board. We test it at our own bench, repair it at component level where that will last, and replace it only when it will not.

  • Control and display board repair
  • Motor inverter board repair
  • Power surge and burnt track damage
  • Board replacement when repair will not last
Book this repair Price agreed before any work starts.
A stainless steel washing machine drum mid-cycle
04

Drum, bearing and spider arm repair

A loud rumble in the spin is almost always the bearings, and left alone it wears out the shaft and the tub as well. We strip the machine down, replace the bearings and seals, and check the drum and spider arm while it is open.

  • Drum bearing and oil seal replacement
  • Spider arm (drum support) replacement
  • Drum and tub replacement
  • Shock absorbers and suspension springs
Book this repair Price agreed before any work starts.
The open door and rubber gasket of a front load washing machine
05

Door, door lock and gasket replacement

The gasket is the rubber ring that seals the drum. When it tears or grows mould the machine leaks onto the floor. We replace gaskets, door glass, hinges and interlocks to the original fit.

  • Door gasket (bellow) replacement
  • Door glass and frame replacement
  • Door lock and interlock repair
  • Hinge and handle repair
Book this repair Price agreed before any work starts.
A technician repairing an appliance part at a workbench
06

Motor, drain pump and inlet valve repair

Motors, carbon brushes, drain pumps and inlet valves do the heavy work in a washing machine and wear out first. We test each one and replace only the part that has actually failed.

  • Motor and carbon brush replacement
  • Drain pump replacement
  • Water inlet valve replacement
  • Pressure switch and sensor faults
Book this repair Price agreed before any work starts.
A front load washer and dryer installed in a home laundry room
07

Installation and uninstallation

A badly fitted machine shakes, leaks and wears out early. We connect the inlet and drain properly, take out the transit bolts, level the machine and run a test wash before we leave.

  • New machine installation and demo
  • Uninstallation before shifting
  • Inlet tap, hose and drain fitting
  • Levelling and stand fitting
Book this repair Price agreed before any work starts.
A gloved hand cleaning the glass door of a washing machine
08

General service and drum cleaning

Hard borewell water leaves scale on the heater and drum, and old detergent turns into smell and mould. A regular service clears it out and catches small faults before they turn into big bills.

  • Descaling and deep drum cleaning
  • Filter and detergent drawer cleaning
  • Gasket cleaning and mould removal
  • A full check-up with honest advice
Book this repair Price agreed before any work starts.

Machines we repair

Whatever kind you have.

  • Front load

    The drum lies on its side behind a glass door. Gentle on clothes and light on water, with more electronics, a door lock and a rubber gasket to look after.

  • Top load

    Fully automatic, loaded from the top, with an agitator or a pulsator at the bottom of the tub. Quick to load and quick through a cycle.

  • Semi-automatic

    Twin tub machines with a wash tub and a spin tub side by side. Simple, tough and nearly always worth repairing.

  • Washer dryer

    A front loader with a dryer built in, so it adds a heater, a condenser and a fan to everything a front loader already has.

Common problems

What people usually call us about.

Tap a problem to open WhatsApp with it already written. Add the brand and, if you can, a short video.

The process

Four steps, no surprises.

  1. 01

    Call or WhatsApp

    Tell us the brand and what the machine is doing. A short video of the fault helps a lot.

  2. 02

    Doorstep diagnosis

    A technician comes to you, finds the fault and explains it in plain words.

  3. 03

    Price first, then repair

    You get the price before any work starts. Many repairs are finished on the spot.

  4. 04

    Tested and handed back

    We run a test cycle with you and leave the machine clean, level and working.

Certified Washing Machine Experts

Not sure which repair you need?

Describe what the machine is doing, or send a video on WhatsApp. We will tell you the likely fault and what it should cost before anyone visits.